Back Door: Reassembly

INSTALL LUGGAGE COMPARTMENT DOOR GARNISH SUB-ASSEMBLY OUTSIDE
INSTALL HIGH MOUNTED STOP LIGHT GASKET (See REASSEMBLY )
INSTALL HIGH MOUNTED STOP LIGHT ASSEMBLY (See REASSEMBLY )
INSTALL HIGH MOUNTED STOP LIGHT SOCKET AND WIRE (See REASSEMBLY )
INSTALL HIGH MOUNTED STOP LIGHT BULB (See REASSEMBLY )
INSTALL BACK DOOR HANDLE ASSEMBLY OUTSIDE
1. Apply body grease to the sliding parts on the back door handle assembly outside.
2. Install the back door handle assembly outside with the 2 nuts.
  Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf)
  
  Fig 1: Identifying Back Door Handle Assembly Outside With Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the link rod.
INSTALL BACK DOOR LOCK ASSEMBLY
1. Apply body grease to the sliding parts on the back door lock assembly.
2. Install the back door lock assembly with the 3 bolts.
  Torque: 12.5 N*m (127 kgf*cm, 9 ft.*lbf)
  
  Fig 2: Identifying Back Door Lock Assembly With Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the connector and install the clamp.
4. Install the back door outside handle control cable.
INSTALL BACK DOOR WEIGHT
1. Install the back door weight with the 3 bolts.
  Torque: 6.0 N*m (61 kgf*cm, 53 in.*lbf)
  
  Fig 3: Identifying Back Door Weight With Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the clamp.
INSTALL REAR SPOILER (See INSTALLATION )
INSTALL BACK DOOR TRIM COVER LH
INSTALL BACK DOOR TRIM COVER RH
INSTALL REAR WIPER MOTOR (See INSTALLATION )
INSTALL BACK DOOR TRIM PANEL ASSEMBLY
INSTALL ASSIST STRAP ASSEMBLY
INSTALL ASSIST STRAP HOLE COVER
INSTALL BACK WINDOW PANEL TRIM UPPER
INSTALL REAR WIPER MOTOR GROMMET (See INSTALLATION )
INSTALL REAR WIPER ARM AND BLADE ASSEMBLY (See INSTALLATION )
INSTALL REAR WIPER ARM COVER (See INSTALLATION )