Rear Wiper Motor: Installation

INSTALL REAR WIPER MOTOR
1. Install the rear wiper motor with the 3 bolts.
  Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf)
2. Connect the connector.
  
  Fig 1: Locating Rear Wiper Motor Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL BACK DOOR TRIM PANEL ASSEMBLY
INSTALL ASSIST STRAP ASSEMBLY
INSTALL ASSIST STRAP HOLE COVER
INSTALL REAR WIPER MOTOR GROMMET
1. Install the rear wiper motor grommet with the position mark facing upward as shown in the illustration.
  
  Fig 2: Identifying Rear Wiper Motor Grommet With Position Mark
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR WIPER ARM AND BLADE ASSEMBLY
1. Operate the rear wiper, and stop the rear wiper motor at the automatic stop position.
2. Clean the wiper arm serrations.
3. Clean the wiper pivot serrations with a wire brush (when reinstalling).
  
  Fig 3: Cleaning Wiper Arm Serrations With Wire Brush
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Install the rear wiper arm and blade assembly with the nut at the position as shown in the illustration.
  Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf)
  
  HINT:
  
  Hold the arm hinge by hand to fasten the nut.
  
  Fig 4: Identifying Ceramic Line
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR WIPER ARM COVER
1. Install the rear wiper arm cover.
2. Operate the rear wiper while spraying water or washer fluid on the windshield.
3. Make sure that the wiper function properly and there is no interference with the vehicle body.