Transmission Control Cable Assembly: Removal

PRECAUTION
HINT:

(See PRECAUTION )
SEPARATE BATTERY NEGATIVE TERMINAL
REMOVE PARKING BRAKE HOLE COVER SUB-ASSEMBLY (See REMOVAL )
REMOVE UPPER CONSOLE PANEL (See REMOVAL )
REMOVE CONSOLE BOX CARPET
HINT:

(See REMOVAL )
REMOVE REAR CONSOLE BOX SUB-ASSEMBLY (See REMOVAL )
REMOVE CENTER AIRBAG SENSOR ASSEMBLY
HINT:

(See REMOVAL )
SEPARATE OXYGEN SENSOR CONNECTOR
1. Remove the foot rest.
2. Pull up the floor carpet.
3. Disconnect the oxygen sensor connector.
REMOVE FLOOR PANEL BRACE FRONT
1. Remove the 2 nuts and floor panel brace.
REMOVE FRONT EXHAUST PIPE ASSEMBLY
REMOVE NO.1 FRONT FLOOR HEAT INSULATOR
1. Remove the 3 nuts and heat insulator.
REMOVE AIR CLEANER ASSEMBLY WITH HOSE
REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
1. Remove the nut and disconnect control cable from control shaft lever.
2. Remove the clip and disconnect the control cable from the bracket.
  
  Fig 1: Identifying Control Cable With Bracket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Disconnect the control cable from control cable support.
  
  Fig 2: Locating Control Cable Support
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Remove the 2 nuts and separate the control cable from the body.
  
  Fig 3: Locating Nuts For Separating Control Cable
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Remove the cable end from the floor shift assembly.
  
  Fig 4: Locating Control Cable
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Using a screwdriver, disconnect the control cable from the shift lever plate.
  HINT:
  
  Tape up the screwdriver tip before use.
  
  Fig 5: Positions For Disconnecting Control Cable
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. Remove the 2 bolts.
8. Pull out the control cable assembly from the body.
9. Remove the retainer from the shift cable.