How To Proceed With Troubleshooting

1. VEHICLE BROUGHT TO WORKSHOP 

   NEXT: Go to Next Step. 

2. CUSTOMER PROBLEM ANALYSIS (SEE  CUSTOMER PROBLEM ANALYSIS CHECK   ) 

   NEXT: Go to Next Step. 

3. CHECK AND CLEAR DTCS (SEE  DTC CHECK/CLEAR   ) 

   NEXT: Go to Next Step. 

4. PROBLEM SYMPTOM CONFIRMATION 
   1. SYMPTOM DOES NOT OCCUR: GO TO STEP 5 
   2. SYMPTOM OCCURS: GO TO STEP   6 
5. SYMPTOM SIMULATION (SEE  ELECTRONIC CIRCUIT INSPECTION PROCEDURE  ) 

   NEXT: Go to Next Step. 

6. DTC CHECK (SEE  DTC CHECK/CLEAR   ) 
   1. THERE IS NO OUTPUT: GO TO STEP 7 
   2. THERE IS OUTPUT: GO TO STEP   8 
7. PROBLEM SYMPTOMS TABLE (SEE  PROBLEM SYMPTOMS TABLE   ) 
   1. CHECK FOR FLUID LEAKAGE AND GO TO STEP 10 
8. DTC CHART (SEE  DIAGNOSTIC TROUBLE CODE CHART   ) 

   NEXT: Go to Next Step. 

9. CIRCUIT INSPECTION (SEE  DTC C0200/31 RIGHT FRONT SPEED SENSOR CIRCUIT, DTC C0205/32 LEFT FRONT SPEED SENSOR CIRCUIT, DTC C1235/35 FOREIGN MATTER IS ATTACHED ON TIP OF RIGHT FRONT SENSOR, DTC C1236/36 FOREIGN MATTER IS ATTACHED ON TIP OF LEFT FRONT SENSOR   to  TS TERMINAL CIRCUIT   ) 

   NEXT: Go to Next Step. 

10. IDENTIFICATION OF PROBLEM 

    NEXT: Go to Next Step. 

11. REPAIR 

    NEXT: Go to Next Step. 

12. CONFIRMATION TEST 

    NEXT 

    END 

HINT:

Step  3, 6, 9, and  12:

Diagnostic steps permitting the use of the hand-held tester.

Fail safe function:

When a failure occurs in the ABS system, the ABS warning light turns on and ABS operation is prohibited.

In addition to this, when there is a failure which disables EBD operation, the brake warning light also turns on and EBD operation is prohibited.