Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
TYPICAL ENABLING CONDITIONS SPECIFICATIONS
| The monitor will run whenever the following DTCs are not present | See LIST OF DISABLE A MONITOR |
| Battery voltage | 11 V or more |
| Fuel system | Closed Loop (for 13 sec or more) |
| Warm-up condition to enable air fuel ratio learning control | The conditions are met |
| Either of the following conditions is met: | |
| Engine RPM | Less than 1,100 rpm |
| Intake air amount | 0.22 g/rev or more |