Section 746 (Seat Belt PRETENSIONER (Rear)): Inspection

WARNING: This page is about a different car, the 2003 Lexus LS 430. However, it is still accessible from the selected car via links, so may be relevant.

PRETENSIONER IS NOT ACTIVATED
1. Perform a diagnostic system check (See DIAGNOSTICS ).
2. Perform a visual check which includes the following items with the rear seat outer belt removed from the vehicle.
  - Check for cuts and cracks in, or marked discoloration on the package tray trim panel.
  - Check for cuts and cracks in wire harness, and for chipping in connectors.
    
    Fig 1: Checking Cuts And Cracks In, Or Marked Discoloration On Package Tray Trim Panel
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  - Check for deformation of the package tray panel.
    
    Fig 2: Checking Deformation Of Package Tray Panel
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  - Check for cuts and minute cracks in wire harness or marked discoloration on the rear seat outer belt.
  CAUTION: For removal and installation of the rear seat outer belt, see REMOVAL and INSTALLATION .
  Be sure to follow the correct procedure.
PRETENSIONER IS ACTIVATED
1. Perform a diagnostic system check (See DIAGNOSTICS ).
  
  Fig 3: Identifying Pretensioner
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Perform a visual check which includes the following items with the rear seat outer belt removed from the vehicle.
  - Check for deformation of the package tray panel.
  - Check for damage on the connector and wire harness.
    
    Fig 4: Checking For Deformation Of Package Tray Panel
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002