Section 27 (P-HEV Drive Motor System (Diagnostics) (1 Of 3))
WARNING: This page is about a different variant/trim than selected.
- Basic Diagnostic Procedure
- Check List For Interview
- General Description
- Electrical Component Location
- Control Module I/O Signal
- Inspection Mode
- Procedure
- Notes
- Inspection Mode 1
- Inspection Mode 2
- Inspection Mode 3
- Inspection Mode 4
- Inspection Mode 5
- Inspection Mode 6
- Inspection Mode 7
- Inspection Mode 8
- Inspection Mode 9
- Inspection Mode 10
- Inspection Mode 11
- Inspection Mode 12
- Inspection Mode 13
- Inspection Mode 14
- Inspection Mode 15
- Inspection Mode 16
- Inspection Mode 17
- Inspection Mode 18
- Inspection Mode 19
- Inspection Mode 20
- Inspection Mode 21
- Inspection Mode 22
- Inspection Mode 23
- Inspection Mode 24
- Inspection Mode 25
- Inspection Mode 26
- Inspection Mode 27
- Inspection Mode 28
- Inspection Mode 29
- Inspection Mode 30
- Inspection Mode 31
- Procedure
- Diagnosis System
- Warning Light Illumination Pattern
- Diagnostic Procedure For Subaru Select Monitor Communication
- Data Monitor
- Freeze Frame Data
- Work Support
- All Readiness Diagnostic Code(s)
- Diagnostic Trouble Code (DTC)
- Diagnostic Procedure With Diagnostic Trouble Code (DTC)
- DTC P0340-00: Camshaft Position Sensor "A" Circuit Bank 1 Or Single Sensor
- DTC P0340-31: Camshaft Position Sensor "A" Circuit Bank 1 Or Single Sensor No Signal
- DTC P062F-44: Internal Control Module EEPROM Data Memory Failure
- DTC P06B0-1C: Generator Control Module Position Sensor Ref Power Source Circuit Voltage Out Of Range
- DTC P06D6-1C: Generator Control Module Offset Power Circuit Voltage Out Of Range
- DTC P0A00-11: Motor Electronics Coolant Temperature Sensor Circuit Short To Ground
- DTC P0A00-15: Motor Electronics Coolant Temperature Sensor Circuit Short To Battery Or Open
- DTC P0A08-12: Dc/Dc Converter Status Circuit Short To Battery
- DTC P0A08-14: Dc/Dc Converter Status Circuit Short To Ground Or Open
- DTC P0A11-12: Dc/Dc Converter Enable Circuit Short To Battery
- DTC P0A11-14: Dc/Dc Converter Enable Circuit Short To Ground Or Open
- DTC P0A1A-47: Generator Control Module Watchdog/Safety MC Failure
- DTC P0A1A-49: Generator Control Module Internal Electronic Failure
- DTC P0A1B-1F: Generator Control Module Circuit Intermittent
- DTC P0A3F-16: Drive Motor "A" Position Sensor Circuit Voltage Below Threshold
- DTC P0A3F-1F: Drive Motor "A" Position Sensor Circuit Intermittent
- DTC P0A3F-21: Drive Motor "A" Position Sensor Signal Amplitude < Minimum
- DTC P0A3F-22: Drive Motor "A" Position Sensor Signal Amplitude>Maximum
- DTC P0A4B-16: Generator Position Sensor Circuit Voltage Below Threshold
- DTC P0A4B-1F: Generator Position Sensor Circuit Intermittent
- DTC P0A4B-21: Generator Position Sensor Signal Amplitude < Minimum
- DTC P0A4B-22: Generator Position Sensor Signal Amplitude>Maximum
- DTC P0A60-12: Drive Motor "A" Phase V Current (High Resolution) Circuit Short To Battery
- DTC P0A60-14: Drive Motor "A" Phase V Current (High Resolution) Circuit Short To Ground Or Open
- DTC P0A60-1C: Drive Motor "A" Phase V Current (High Resolution) Circuit Voltage Out Of Range
- DTC P0A60-1F: Drive Motor "A" Phase V Current (High Resolution) Circuit Intermittent
- DTC P0A63-12: Drive Motor "A" Phase W Current (High Resolution) Circuit Short To Battery
- DTC P0A63-14: Drive Motor "A" Phase W Current (High Resolution) Circuit Short To Ground Or Open
- DTC P0A63-1C: Drive Motor "A" Phase W Current (High Resolution) Circuit Voltage Out Of Range
- DTC P0A63-1F: Drive Motor "A" Phase W Current (High Resolution) Circuit Intermittent
- DTC P0A78-72: Drive Motor "A" Inverter Actuator Stuck Open
- DTC P0A78-73: Drive Motor "A" Inverter Actuator Stuck Closed
- DTC P0A78-9E: Drive Motor "A" Inverter Stuck On