LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> Crosstrek Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (HVAC System (Heater, Ventilator And A/C) (Except For HEV)) >> Evaporator Sensor >> Removal

Evaporator Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
CAUTION: Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
  1. Using the refrigerant recovery system, discharge refrigerant. Ref. to AIR CONDITIONER (EXCEPT FOR HEV)>REFRIGERANT RECOVERY PROCEDURE>PROCEDURE .
  2. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
  3. Drain the coolant from the radiator. Ref. to COOLING (H4DO (EXCEPT FOR HEV))>ENGINE COOLANT>REPLACEMENT>DRAINING OF ENGINE COOLANT .
  4. Remove the evaporator assembly - cooling. Ref. to AIR CONDITIONER (EXCEPT FOR HEV)>EVAPORATOR> REMOVAL .
  5. Remove the evaporator sensor.
    1. Remove the evaporator sensor as shown in the figure.
      G11245706Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals