LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (P-HEV Hybrid Powertrain Control System (Diagnostics) (2 Of 2)) >> Diagnostic Procedure with Diagnostic Trouble Code (DTC) >> DTC P1CD8-00: Hybrid/EV Powertrain Control Module Processor Or Monitoring Processor Charging Permission Signal Internal Failure >> Notes

DTC P1CD8-00: Hybrid/EV Powertrain Control Module Processor Or Monitoring Processor Charging Permission Signal Internal Failure: Notes

WARNING: This page is about a different variant/trim than selected.

1. - 

Outline of diagnosis: 

The charger gate permission signal from Hybrid vehicle control ECU assembly is faulty

(1 trip detection logic)

Trouble symptom: 

Plug-in charging suspended

CAUTION: Before performing diagnosis, refer to "CAUTION" in "General Description". Ref. to P-HEV HYBRID POWERTRAIN CONTROL (DIAGNOSTICS)>GENERAL DESCRIPTION>CAUTION .
G13618093Courtesy of SUBARU OF AMERICA, INC.
  1. CHECK DTC  .

    Read the following DTCs using Subaru Select Monitor. Ref. to P-HEV HYBRID POWERTRAIN CONTROL (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) . Ref. to PLUG-IN BATTERY CHARGER (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .

    • P-HEV Hybrid Powertrain Control
    • Plug-in Battery Charger
    NOTE:
    Malfunction contents System Related DTC
    Microcomputer malfunction P-HEV Hybrid Powertrain Control P060647 HYBRID/EV POWERTRAIN CONTROL MODULE PROCESSOR WATCHDOG/SAFETY MCU FAILURE
    P060687 HYBRID/EV POWERTRAIN CONTROL MODULE PROCESSOR TO MONITORING PROCESSOR MISSING MESSAGE
    P060A47 HYBRID/EV POWERTRAIN CONTROL MODULE MONITORING PROCESSOR WATCHDOG/SAFETY MCU FAILURE
    P060A87 HYBRID/EV POWERTRAIN CONTROL MODULE PROCESSOR FROM MONITORING PROCESSOR MISSING MESSAGE
    P1C9E9F HYBRID/EV SYSTEM RESET STUCK OFF
    P1CD900 HYBRID/EV POWERTRAIN CONTROL MODULE PROCESSOR AND MONITORING PROCESSOR CHARGING PERMISSION SIGNAL STUCK ON
    Plug-in Battery Charger P060B49 PLUG-IN CONTROL MODULE A/D PROCESSING INTERNAL ELECTRONIC FAILURE
    Communication system malfunction Plug-in Battery Charger U019B87 LOST COMMUNICATION WITH HYBRID/EV BATTERY CHARGER CONTROL MODULE MISSING MESSAGE

    When "Only DTC P1CD800 is displayed" or "DTC other than above is displayed", go to  A.

    When DTCs related to [P-HEV Hybrid Powertrain Control], mentioned above, are simultaneously displayed, go to  B.

    When DTCs related to [Plug-in Battery Charger], mentioned above, are simultaneously displayed, go to  C.

    Yes  :

    1. Replace Hybrid vehicle control ECU assembly. Ref. to HYBRID ELECTRIC VEHICLE>HYBRID POWERTRAIN CONTROL MODULE .
    2. Perform the diagnosis for the simultaneously displayed DTCs.
      NOTE: If more than one DTC is simultaneously displayed, perform the diagnosis in the order described in the above.
    3. Perform the diagnosis for the simultaneously displayed DTCs.
    NOTE: If more than one DTC is simultaneously displayed, perform the diagnosis in the order described in the above.

    No  : -