Section 11 (HVAC System (Heater, Ventilator And A/C) (HEV)): Evaporator: Installation

WARNING: This page is about a different variant/trim than selected.

CAUTION:

If the evaporator has been replaced, add an appropriate amount of compressor oil to the compressor. Ref. to AIR CONDITIONER (HEV)>COMPRESSOR OIL>ADJUSTMENT .
Replace the O-rings with new parts, and then apply compressor oil to install completely.
Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .

Install the evaporator sensor to the specified location. Ref. to AIR CONDITIONER (HEV)>EVAPORATOR SENSOR>INSTALLATION .
Install the evaporator assembly.
Install the case assembly - heater unit.
Install the motor - actuator mix. Ref. to AIR CONDITIONER (HEV)>AIR MIX DOOR ACTUATOR>INSTALLATION .
Attach the heater core. Ref. to AIR CONDITIONER (HEV)>HEATER CORE>INSTALLATION .
Install the internal condenser. Ref. to AIR CONDITIONER (HEV)>CONDENSER>INSTALLATION>INTERIOR CONDENSER .
Install the heater and cooling unit assembly. Ref. to AIR CONDITIONER (HEV)>HEATER AND COOLING UNIT>INSTALLATION .
Connect the battery ground terminal. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
Fill engine coolant. (Engine side) Ref. to COOLING (H4DO (HEV))>ENGINE COOLANT>REPLACEMENT>FILLING OF ENGINE COOLANT .