Heater and Cooling Unit: Installation
WARNING: This page is about a different variant/trim than selected.
CAUTION:
- Replace the O-rings with new parts, and then apply compressor oil to install completely.
- Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
- Install the heater and cooling unit assembly.
Tightening torque:
7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
- Install the hose - drain.
- Install the duct - foot. Ref. to AIR CONDITIONER (HEV)>HEATER DUCT>INSTALLATION>FOOT .
- Install the duct - rear heater front. Ref. to AIR CONDITIONER (HEV)>HEATER DUCT>INSTALLATION>FRONT .
- Install the instrument panel assembly and the beam COMPL - steering. Ref. to EXTERIOR/INTERIOR TRIM>INSTRUMENT PANEL ASSEMBLY>INSTALLATION .
- Install the hose - heater outlet and the hose - heater inlet.
- Install expansion valve - cooler assembly hose and pipe - return assembly.
Tightening torque:
7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
- Install the hose - pressure discharge and the pipe - sensor.
Tightening torque:
7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
- Install the air intake boot. Ref. to INTAKE (INDUCTION) (H4DO (EXCEPT FOR HEV))>AIR INTAKE BOOT>INSTALLATION .
- Connect the battery ground terminal. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
- Fill engine coolant. (Engine side) Ref. to COOLING (H4DO (HEV))>ENGINE COOLANT>REPLACEMENT>FILLING OF ENGINE COOLANT .