LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> WRX STI Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Emission Control Systems (Aux. Emission Control Devices) (Except For STI)) >> EGR Control Valve >> Removal

EGR Control Valve: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the collector cover. Refer to INTAKE (INDUCTION) (EXCEPT FOR STI)>COLLECTOR COVER>REMOVAL .
  2. Disconnect the ground terminal from battery sensor. Refer to NOTE>NOTE>BATTERY .
  3. Lift up the vehicle.
  4. Remove the under cover. Refer to EXTERIOR/INTERIOR TRIM>FRONT UNDER COVER>REMOVAL .
  5. Drain approximately 3.0 L (3.2 US qt, 2.6 Imp qt) of coolant. Refer to COOLING (EXCEPT FOR STI)>ENGINE COOLANT>REPLACEMENT>DRAINING OF ENGINE COOLANT .
  6. Remove the intercooler. Refer to INTAKE (INDUCTION) (EXCEPT FOR STI)>INTERCOOLER>REMOVAL .
  7. Remove the EGR pipe. Refer to EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES) (EXCEPT FOR STI)>EGR PIPE>REMOVAL .
  8. Remove the bolts which secure the EGR cooler to the EGR control valve, and remove the bolts which secure the EGR control valve bracket A to the EGR control valve bracket B.
    G13258695Courtesy of SUBARU OF AMERICA, INC.
  9. Disconnect the connector (A) and preheater hose (B) from EGR control valve, and remove the EGR control valve.
    G09479967Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals