Cam Carrier RH
WARNING: This page is about a different variant/trim than selected.
- Remove the engine from the vehicle. Refer to MECHANICAL (EXCEPT FOR STI)>ENGINE ASSEMBLY>REMOVAL .
- Remove the timing chain RH. Refer to MECHANICAL (EXCEPT FOR STI)>TIMING CHAIN ASSEMBLY>REMOVAL>TIMING CHAIN RH .
- Remove the rocker cover RH. Refer to MECHANICAL (EXCEPT FOR STI)>ROCKER COVER>REMOVAL>ROCKER COVER RH .
- Remove the oil pipe assembly. Refer to LUBRICATION (EXCEPT FOR STI)>OIL PIPE>REMOVAL>OIL PIPE ASSY .
- Remove the clip holding the engine wiring harness from cam carrier RH.
- Disconnect the water pipe hose from oil pan upper and EGR cooler, and remove the water pipe assembly.
- When disassembling the cam carrier RHNOTE: When disassembling the cam carrier RH, perform the following steps also.
- Remove the scavenge pump. Refer to LUBRICATION (EXCEPT FOR STI)>SCAVENGE PUMP>REMOVAL .
- Remove the cam sprocket RH. Refer to MECHANICAL (EXCEPT FOR STI)>CAM SPROCKET>REMOVAL>CAM SPROCKET RH .
- Set the part so that the cam carrier RH is on the upper side.
- Loosen the bolts holding the cam carrier RH equally, a little at a time in numerical sequence as shown in the figure and remove the cam carrier RH.
- Remove the O-ring and the roller rocker arm from cylinder head RH.NOTE: Be careful not to confuse the roller rocker arms.
- Remove the valve shim and the roller rocker arm pivot from cylinder head RH.NOTE: Be careful not to confuse the valve shim and the roller rocker arm pivot.
- Remove the liquid gasket from cam carrier RH and cylinder head RH.