LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> BRZ Limited, Automatic Trans >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Accessory Drive Belts >> Engine Mechanical System >> Engine Rear Oil Seal (FA20) >> Removal

Engine Rear Oil Seal (FA20): Removal

  1. Removal of automatic transmission ASSY (transmission A/T) (Refer to REMOVAL )
  2. Removal of manual transmission ASSY (transmission M/T) (Refer to REMOVAL )
  3. Drive plate & ring gear SUB-ASSY removal (transmission A/T)
    1. Use the SST to secure the crankshaft pulley.

      SST 18355AA000, 18334AA000

      G08554179Courtesy of SUBARU OF AMERICA, INC.
    2. Remove the eight bolts to remove the drive plate spacer FR and drive plate & ring gear SUB-ASSY.
    G12586584Courtesy of SUBARU OF AMERICA, INC.
  4. Clutch cover ASSY removal (transmission M/T) (Refer to REMOVAL )
  5. Clutch disc ASSY removal (transmission M/T) (Refer to REMOVAL )
  6. Flywheel SUB-ASSY removal (transmission M/T)
    1. Use the SST to secure the crankshaft pulley.

      SST 18355AA000, 18334AA000

      G08554179Courtesy of SUBARU OF AMERICA, INC.
    2. Remove the eight bolts and remove the flywheel SUB-ASSY.
      G12586586Courtesy of SUBARU OF AMERICA, INC.
  7. Crank angle sensor plate removal
    1. Remove the crank angle sensor plate.
  8. Engine rear oil seal removal
    1. Make a slit to the oil seal lip using a cutter knife.
      G12586587Courtesy of SUBARU OF AMERICA, INC.
    2. Remove the oil seal using a flat tip screwdriver wrapped with protective tape.
      CAUTION: Make sure that there are no scratches in the fitting area of crankshaft and rear oil seal retainer.
      NOTE: If the crankshaft is scratched, repair it with sandpaper (# 400).
scientia non olet · About LEMON Manuals