Section 2 (M/T Clutch System): Clutch: Removal
WARNING: This page is about a different variant/trim than selected.
- Removal of manual transmission ASSY (refer to
REMOVAL
)
- Removal of clutch release fork SUB-ASSY
- Remove the clutch release fork SUB-ASSY and the release fork support.
- Remove the clutch release fork SUB-ASSY and the clutch release bearing ASSY from the manual transmission ASSY.
- Clean the input shaft and release fork support.
- Removal of clutch release bearing ASSY
- Remove 2 release bearing hub clips to remove the clutch release bearing ASSY.
- Removal of release bearing hub clip
- Remove 3 release bearing hub clips from the clutch release bearing ASSY.
- Cleaning of clutch release fork SUB-ASSY and clutch release bearing ASSY
- Clean the clutch release fork SUB-ASSY and clutch release bearing ASSY.
- Removal of clutch release fork boot
- Remove the clutch release fork boot from the manual transmission ASSY.
- Removal of release fork support
- Remove the release fork support from the manual transmission ASSY.
- Removal of clutch cover ASSY
- Mark an alignment mark on the clutch cover ASSY and the flywheel.
- Remove 6 bolts to remove the clutch cover ASSY.
CAUTION: Prevent the clutch disc ASSY from falling off. - Mark an alignment mark on the clutch cover ASSY and the flywheel.
- Removal of clutch disc ASSYCAUTION: Keep oil and foreign substances away from the lining area, pressure plate, and flywheel clutch disc sliding area of the clutch disc ASSY.