LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> Legacy 2.5i Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Continuously Variable Transaxle (CVT) (H6DO)) >> Intermediate Case >> Removal

Intermediate Case: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transmission assembly from vehicle body. Ref. to REMOVAL , Automatic Transmission Assembly.
  2. Remove the extension case. Ref. to REMOVAL , Extension Case.
  3. Remove the parking pawl. Ref. to REMOVAL , Parking Pawl.
  4. Remove the rear drive shaft. Ref. to REMOVAL , Rear Drive Shaft.
  5. Remove the transfer clutch assembly. Ref. to REMOVAL , Transfer Clutch.
  6. Remove the transfer reduction driven gear assembly. Ref. to REMOVAL , Transfer Reduction Driven Gear.
  7. Remove the intermediate case.
    NOTE:
    • The total number of intermediate case mounting bolts is 14.
    • Inside the transmission is a single bolt (arrowed).
    Fig 1: Identifying Transmission Inside Bolt
    G09482108Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the CVTF filter.
    Fig 2: Identifying CVTF Filter
    G09482109Courtesy of SUBARU OF AMERICA, INC.
  9. Remove the O-ring from the transmission case.
Fig 3: Identifying O-Rings
G06654544Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals