LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> Legacy 2.5i Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Mechanical (H6DO)) >> Cylinder Head >> Removal

Cylinder Head: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the engine from vehicle. Ref. to REMOVAL , Engine Assembly.
  2. Remove the crank pulley. Ref. to REMOVAL , Crank Pulley.
  3. Remove the chain cover. Ref. to REMOVAL , Chain Cover.
  4. Remove the timing chain assembly. Ref. to REMOVAL , Timing Chain Assembly.
  5. Remove the CAM sprocket. Ref. to REMOVAL , CAM Sprocket.
  6. Remove the crank sprocket. Ref. to REMOVAL , Crank Sprocket.
  7. Remove the camshaft. Ref. to REMOVAL , Camshaft.
  8. Remove the seal bolt shown in the figure.
    Fig 1: Identifying Seal Bolt
    G05667861Courtesy of SUBARU OF AMERICA, INC.
  9. Remove the cylinder head bolts in the numerical order as shown in the figure.
    NOTE: Leave bolts (2) and (4) engaged by three or four threads to prevent the cylinder head from falling.
    Fig 2: Cylinder Head Bolts Loosening Sequence
    G05667862Courtesy of SUBARU OF AMERICA, INC.
  10. While tapping the cylinder head with a plastic hammer, separate it from cylinder block.
  11. Remove the bolts (2) and (4) to remove cylinder head.
  12. Remove the cylinder head gasket.
    CAUTION: Be careful not to scratch the mating surface of cylinder head and cylinder block.
  13. Similarly, remove the cylinder head (RH).
scientia non olet · About LEMON Manuals