DTC P0724 Brake Switch "B" Circuit High: Notes
DTC detecting condition:
Immediately at fault recognition
Trouble symptom:
Gear is not shifted down when climbing a hill or driving down a hill.
CAUTION:
Use CHECK BOARD when measuring the TCM terminal voltage and resistance.
Wiring diagram:
- Non-turbo model (without EyeSight and X mode)
Stop light system Ref. to WIRING SYSTEM>Stop Light System>WIRING DIAGRAM>WITHOUT EyeSight AND X MODE .
- Except for non-turbo model (without EyeSight and X mode)
Stop light system Ref. to WIRING SYSTEM>Stop Light System>WIRING DIAGRAM>EXCEPT FOR MODEL WITHOUT EyeSight AND X MODE .
Fig 2: Brake Switch (B) Circuit High System Wiring Diagram (Except For Model Without Eyesight And X Mode)
- CHECK STOP LIGHT SWITCH.
- Turn the ignition switch to OFF.
- Disconnect the stop light switch connector.
- Measure the resistance between stop light switch.
Terminals
No. 1 - No. 2:
Is the resistance 1 MΩ or more?
- Yes : Go to 2.
- No : Replace the stop light switch. Ref. to BRAKE>Stop Light Switch .
- CHECK HARNESS.
- Disconnect the TCM connector.
- Turn the ignition switch to ON.
- Measure the voltage between TCM connector and chassis ground.
Connector & terminal
(B54) No. 29 (+) - Chassis ground (-):
Is the voltage 10 V or more?
- Yes : Repair the short circuit of harness.
- No : Go to 3.
- CHECK INPUT SIGNAL FOR TCM.
- Connect all connectors.
- Turn the ignition switch to ON.
- Read the data of [Stop Light Switch] using Subaru Select Monitor.
Is "OFF" displayed?
- Yes : Current condition is normal. Check for poor contact in connectors or harnesses, and repair the defective part.
- No : Go to 4.
- CHECK FOR POOR CONTACT.
Is there poor contact in the input signal circuit of stop light switch?
- Yes : Repair the poor contact.
- No : Replace the TCM. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION(TR580)>Transmission Control Module (TCM) . Ref. to CONTINUOUSLY VARIABLE TRANSMISSION(TR690)>Transmission Control Module (TCM) .