- Remove the engine from the vehicle. Ref. to MECHANICAL (H4DOTC)>Engine Assembly>REMOVAL .
- Remove the chain cover. Ref. to MECHANICAL (H4DOTC)>Chain Cover>REMOVAL .
- Remove the timing chain RH. Ref. to MECHANICAL (H4DOTC)>Timing Chain Assembly>REMOVAL>TIMING CHAIN RH .
- Remove the rocker cover RH. Ref. to MECHANICAL (H4DOTC)>Rocker Cover>REMOVAL>ROCKER COVER RH .
- Remove the clip holding the engine harness from cam carrier RH.
Courtesy of SUBARU OF AMERICA, INC.
- Remove the oil pipe assembly from the scavenge pump and cam carrier RH.
Courtesy of SUBARU OF AMERICA, INC.
- Disconnect the water pipe hose from oil pan upper and EGR cooler, and remove the water pipe assembly.
Courtesy of SUBARU OF AMERICA, INC.
- When disassembling the cam carrier RH
NOTE:
When disassembling the cam carrier RH, perform the following steps also.
- Remove the scavenge pump. Ref. to LUBRICATION(H4DO)>Scavenge Pump>REMOVAL .
- Remove the cam sprocket RH. Ref. to MECHANICAL (H4DOTC)>Cam Sprocket>REMOVAL>CAM SPROCKET RH .
- Set the part so that the cam carrier RH is on the upper side.
- Loosen the bolts holding the cam carrier RH equally, a little at a time in numerical sequence as shown in the figure and remove the cam carrier RH.
Courtesy of SUBARU OF AMERICA, INC.
- Remove the O-ring and the roller rocker arm from cylinder head RH.
NOTE:
Be careful not to confuse the roller rocker arms.
Courtesy of SUBARU OF AMERICA, INC.
- Remove the valve shim and the roller rocker arm pivot from cylinder head RH.
NOTE:
Be careful not to confuse the valve shim and the roller rocker arm pivot.
Courtesy of SUBARU OF AMERICA, INC.
- Remove the liquid gasket from cam carrier RH and cylinder head RH.