Extension Case: Assembly

WARNING: This page is about a different variant/trim than selected.

Install the reverse check system. <Ref. to INSTALLATION , Reverse Check System.>
Install the extension case oil seal. <Ref. to REPLACEMENT , Oil Seal.>
Using the ST, install the shifter arm shaft oil seal.
ST1 18657AA000 INSTALLER

ST2 18671AA000 OIL SEAL GUIDE

Fig 1: Installing Shifter Arm Shaft Oil Seal
Courtesy of SUBARU OF AMERICA, INC.
Install the oil plate.

Fig 2: Installing Oil Plate
Courtesy of SUBARU OF AMERICA, INC.
Select the adjusting washer of the bearing, and attach it to the extension case. <Ref. to ADJUSTMENT , Extension Case.>
Install the taper roller bearing (extension case side) outer race to the extension case.
CAUTION: Apply transmission gear oil onto sliding or revolving surfaces before installation.
Install the shift bracket.
Tightening torque:

25 N.m (2.5 kgf-m, 18.4 ft-lb)

Fig 3: Locating Shift Bracket Bolts
Courtesy of SUBARU OF AMERICA, INC.
Attach the oil guide and the transfer driven gear. <Ref. to INSTALLATION , Transfer Drive Gear.>