How To Proceed With Troubleshooting
NOTE:
- Use these procedures to troubleshoot the engine immobiliser system.
- *: Use the SSM3.
- VEHICLE BROUGHT TO WORKSHOP
NEXT
- INSPECT BATTERY VOLTAGE
Standard voltage: 11 to 14 V
If the voltage is below 11V, recharge or replace the battery before proceeding.
NOTE: A simple method to determine whether the battery is depleted is to operate the horn.NEXT
- CAN communication system check
- Check CAN communication system. (Refer to
HOW TO TROUBLESHOOT
)RESULT
Result Proceed to Functioning properly A Not functioning properly B B: GO TO CAN COMMUNICATION SYSTEM (Refer to HOW TO TROUBLESHOOT )
A: Go to Next Step
- Check CAN communication system. (Refer to
HOW TO TROUBLESHOOT
)
- CHECK FOR DTC*
- Check for DTCs and note any codes that are output. (Refer to
DTC CHECK / CLEAR )RESULT
Result Proceed to DTC is not output A Engine related DTC is output B Engine immobiliser system DTC is not output C - Based on the DTCs output above, proceed to each diagnostic procedure.
B: To engine control system
C: PROCEED TO DTC CHART (Refer to DIAGNOSTIC TROUBLE CODE CHART )
A: Go to Next Step
- Check for DTCs and note any codes that are output. (Refer to
DTC CHECK / CLEAR )
- PROBLEM SYMPTOMS TABLE
- Refer to PROBLEM SYMPTOMS TABLE . (Refer to
)RESULT
Result Proceed to Fault is not listed in problem symptoms table A Fault is listed in problem symptoms table B B: Go to step 7
A: Go to Next Step
- Refer to PROBLEM SYMPTOMS TABLE . (Refer to
)
- OVERALL ANALYSIS AND TROUBLESHOOTING*
- Check Current Data Display & Save / System Operation Check Mode. (Refer to CURRENT DATA DISPLAY & SAVE / SYSTEM OPERATION CHECK MODE )
- Terminals of ECU. (Refer to ECM TERMINAL ARRANGEMENT
)
NEXT
- ADJUST, REPAIR OR REPLACE
NEXT
- CHECK FOR DTC*
- Clear the DTCs. (Refer to DTC CHECK / CLEAR )
- Check for DTCs. (Refer to DTC CHECK / CLEAR
)NOTE: Before checking for DTCs, perform the "DTC Output Confirmation Operation" of each diagnostic procedure. (Refer to CURRENT DATA DISPLAY & SAVE / SYSTEM OPERATION CHECK MODE )RESULT
Result Proceed to DTC is not output A Engine immobiliser system DTC is output B B: GO TO DIAGNOSTIC TROUBLE CODE CHART (Refer to )
A: END