Current Data Display & Save

NOTE: Using the SSM3 to read the [Current Data Display & Save] allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the [Current Data Display & Save] information early in troubleshooting is one way to save diagnostic time.

CAUTION: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

Connect the SSM3 to the DLC3.
Turn the ignition switch to ON.
Turn the SSM3 on.
Enter the following menus: [Integ. unit mode] →[Current Data Display & Save]
Enter the following menus: [Engine Control System] →[Current Data Display & Save]

Read the [Current Data Display & Save] according to the display on the SSM3.

MAIN BODY

Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
[Ignition]	Ignition switch ON signal / OFF or ON	OFF: Ignition switch ACC or off ON: Ignition switch ON	-
[ACC SW]	Ignition switch ACC signal / OFF or ON	OFF: Ignition switch ACC or off ON: Ignition switch ON	-
[Key Unlock Warning SW]	Unlock warning switch signal / OFF or ON	OFF: No key in ignition key cylinder ON: Key inserted in ignition key cylinder	-
[BATT voltage (control)]	Battery power supply voltage / 10 to 15V	11 to 14 V	-
[BATT voltage (BACKUP)]	Battery power supply backup voltage / 10 to 15V	11 to 14 V	-
[ABS_CM Power Voltage]	Ignition switch power supply voltage / 10 to 15V	11 to 14 V	-
[ACC voltage]	ACC switch power supply voltage / 10 to 15V	11 to 14 V	-
[Immobilizer pilot lamp output]	Security indicator light status / OFF or ON	OFF: Security indicator light OFF ON: Security indicator light blinks	-
[Immobilizer power Supply]	Main body ECU (multiplex network body ECU) engine immobiliser system power supply output status / OFF or ON	OFF: Engine immobiliser unset ON: Engine immobiliser set	-

ENGINE AND ECT

Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
[Immobilizer Fuel Cut]	Status of immobiliser fuel cut / ON or OFF	-	-
[Immobilizer Fuel Cut History]	Status of immobiliser fuel cut history / ON or OFF	-	-

System Operation Check Mode

NOTE: Using the SSM3 to perform [System Operation Check Mode] allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing [System Operation Check Mode] early in troubleshooting is one way to save diagnostic time. [Current Data Display & Save] information can be displayed while performing [System Operation Check Mode].

Connect the SSM3 to the DLC3.
Turn the ignition switch to ON.
Turn the SSM3 on.
Enter the following menus: [Integ. unit mode] →[Work Support] →[System Operation Check Mode]

According to the display on the SSM3, perform the [System Operation Check Mode].

MAIN BODY

Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
[Security Indicator]	Security indicator light	[ON]/[OFF]	-

Current Data Display & Save / System Operation Check Mode