LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2014 >> BRZ Premium >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Engine Immobilizer System (W/O Entry Start) >> Engine Immobilizer System (Without Entry & Start System) >> DTC Check / Clear

DTC Check / Clear

  1. CHECK FOR MAIN BODY ECM (MULTIPLEX NETWORK BODY ECM) DTC
    1. Connect the SSM3 to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the SSM3 on.
    4. Enter the following menus: [Integ. unit mode] →[Diagnostic Code(s) Display]
    5. Check for DTCs.
  2. CHECK FOR ECM DTC
    1. Connect the SSM3 to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the SSM3 on.
    4. Enter the following menus: [Engine Control System] →[Diagnostic Code(s) Display]
    5. Check for DTCs.
  3. CLEAR MAIN BODY ECM (MULTIPLEX NETWORK BODY ECM) DTC
    1. Connect the SSM3 to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the SSM3 on.
    4. Enter the following menus: [Integ. unit mode] →[Clear Memory]
    5. Clear the DTCs.
  4. CLEAR ECM DTC
    1. Connect the SSM3 to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the SSM3 on.
    4. Enter the following menus: [Engine Control System] →[Diagnostic Code(s) Display]
    5. Clear the DTCs.
scientia non olet · About LEMON Manuals