Clutch Pedal: Installation

WARNING: This page is about a different variant/trim than selected.

Install in the reverse order of removal.
CAUTION: Always use a new clevis pin.

Tightening torque:

T: 18 N.m (1.8 kgf-m, 13.3 ft-lb)
Fill the recommended clutch fluid. Refer to CLUTCH FLUID .
Bleed air from the clutch system. Refer to PROCEDURE .
Adjust the clutch pedal. Refer to ADJUSTMENT .
When the clutch pedal has been replaced, perform the clutch sensor calibration mode. Refer to CLUTCH SENSOR CALIBRATION MODE .
NOTE: If necessary, perform the clutch meet position setting. Refer to CLUTCH ENGAGEMENT POSITION SETTING .