Clutch Engagement Position Setting

CAUTION: Subaru Select Monitor is required for Clutch Engagement Position Setting.

NOTE:

When the clutch master cylinder assembly is replaced, use this function to set the engagement position for the clutch stroke sensor.
When the customer requested a change of the accelerator interlocking release timing, use this function to change the engagement position of the clutch stroke sensor in order to change the accelerator interlocking release timing.
The clutch engagement position can be set between 50 - 80%.

Park the vehicle on a safe level surface without obstacles.
Start the engine to warm up.
Connect the Subaru Select Monitor.
On «Main Menu» display, select {Each System Check}.
On «System Selection Menu» display, select {Brake Control System}.
Click the [OK] button after {Parking Brake System} is displayed.
On «Maintenance Operation Mode» display, select {Clutch Engagement Position Setting}.
Release the parking brake. Shift the gear to 1st, then slowly release the clutch pedal, and read "Clutch position current value" on the screen when the vehicle starts to move.
Enter the reading to "Engagement position input value", and press the [Execution] button.
Turn the ignition switch to OFF to end the clutch engagement position setting.
Drive the vehicle, and check the accelerator interlocking release timing.
CAUTION: If the clutch engagement position is not set correctly, early release or release delay of the parking brake may occur at the accelerator interlocking release. After completing the setting, check the accelerator interlocking timing in a safe place, and confirm that neither early release nor release delay occurs.
NOTE:
- When a smaller value than "Engagement position learning value" is entered in "Engagement position input value", the parking brake release timing delays.
- When a larger value than "Engagement position learning value" is entered in "Engagement position input value", the parking brake release timing becomes early.