Clutch Fluid Air Bleeding: Procedure

WARNING: This page is about a different variant/trim than selected.

NOTE: Bleed air from the oil line with help of a co-worker.

Remove the air intake boot assembly. Refer to REMOVAL .
Fit one end of a vinyl tube into the air breather of the operating cylinder, and put the other end into a clutch fluid container.

Fig 1: Identifying Air Breather
Courtesy of SUBARU OF AMERICA, INC.
Slowly depress the clutch pedal several times and keep it depressed. Open the air breather to discharge air together with the clutch fluid. Release the air breather for 1 or 2 seconds. Next, close the air breather, and slowly release the clutch pedal.
CAUTION: Cover the air breather with cloth to prevent clutch fluid from being splashed on surrounding parts when loosening the breather.

Fig 2: Identifying Operating Cylinder And Vinyl Tube
Courtesy of SUBARU OF AMERICA, INC.
Repeat procedure 5), until there are no more air bubbles appearing from the air breather.
Tighten the air breather.
Tightening torque:

T: 7.8 N.m (0.8 kgf-m, 5.8 ft-lb)

Fig 3: Air Bleeder Nut With Torque Specification
Courtesy of SUBARU OF AMERICA, INC.
After stepping on the clutch pedal, make sure that there are no leaks evident in the entire clutch system.
After bleeding the air from clutch system, ensure that the clutch operates properly.
Install the air intake boot assembly. Refer to INSTALLATION .