Radiator Main Fan and Fan Motor: Removal

WARNING: This page is about a different variant/trim than selected.

Remove the collector cover.
NOTE: Follow the steps below when removing the collector cover.
1. Pull up the two points at the rear (A).
2. Pull up the two points at the front (B) while moving them forward.
  
  Fig 1: Removing Collector Cover
  Courtesy of SUBARU OF AMERICA, INC.
Disconnect the ground cable from battery.
Lift up the vehicle.
Remove the under cover. Refer to REMOVAL .
Drain engine coolant. Refer to DRAINING OF ENGINE COOLANT .
Disconnect the integrated connector of radiator main fan & fan motor and radiator sub fan & fan motor.

Fig 2: Locating Radiator Main Fan & Fan Motor And Radiator Sub Fan & Fan Motor Integrated Connector
Courtesy of SUBARU OF AMERICA, INC.
Lower the vehicle.
Remove the air intake duct. Refer to REMOVAL .
Remove the grille bracket.
NOTE: Remove ten clips when removing the grille bracket.

Fig 3: Locating Grille Bracket Mounting Clips
Courtesy of SUBARU OF AMERICA, INC.
Remove the reservoir tank. Refer to REMOVAL .
Remove radiator inlet hoses LH and RH only on radiator side.

Fig 4: Locating Radiator Inlet Hoses LH And RH To Radiator Mounting Clamps
Courtesy of SUBARU OF AMERICA, INC.
Remove the ATF radiator hose from the clip of the radiator fan shroud.
Remove bolts on the upper side of radiator fan shroud.

Fig 5: Locating Radiator Fan Shroud Upper Side Mounting Bolts
Courtesy of SUBARU OF AMERICA, INC.

Fig 6: Locating Radiator Fan Shroud Upper Side Mounting Bolts
Courtesy of SUBARU OF AMERICA, INC.
Remove the radiator fan shroud.
NOTE: When pulling up the radiator fan shroud, be careful not to damage the radiator hose or ATF radiator hose.