PCV Hose Assembly: Installation

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Install the PCV hose assembly C to the intake duct and the cylinder block RH.
NOTE: Use a new clamp for the PCV hose assembly C, fit the cut out in the ST with the protrusion on the clamp as shown in the figure, and lock the clamp.

ST 18353AA000 CLAMP PLIERS

Fig 1: Removing/Installing PCV Hose Clamp Using Clamp Pliers
Courtesy of SUBARU OF AMERICA, INC.

Fig 2: Locating PCV Hose Assembly Clamp
Courtesy of SUBARU OF AMERICA, INC.
Install the intake duct. < Refer to INSTALLATION , Intake Duct. >
Install the turbocharger. < Refer to INSTALLATION , Turbocharger. >
Install the intake manifold. < Refer to INSTALLATION , Intake Manifold. >
Install the PCV hose assembly B to the rocker cover LH, and connect the connector (A) to the PCV hose assembly B.

Fig 3: Locating PCV Hose Assembly B
Courtesy of SUBARU OF AMERICA, INC.
Install the PCV hose assembly A to the rocker cover RH, and connect the connector (A) to the PCV hose assembly A.

Fig 4: Identifying PCV Hose Assembly And Connector
Courtesy of SUBARU OF AMERICA, INC.
Install the collector cover.