Intake Duct: Installation

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Install the PCV hose assembly onto the intake duct.
NOTE: Use a new clamp for the PCV hose assembly, fit the cut out in the ST with the protrusion on the clamp as shown in the figure, and lock the clamp.

ST 18353AA000 CLAMP PLIERS

Fig 1: Pinching Clamp Of PCV Hose Assembly Using ST
Courtesy of SUBARU OF AMERICA, INC.

Fig 2: Locating PCV Hose Clamp
Courtesy of SUBARU OF AMERICA, INC.
Install the intake duct to the intake manifold.
Tightening torque:

17 N.m (1.7 kgf-m, 12.5 ft-lb)

Fig 3: Locating Intake Duct Nut
Courtesy of SUBARU OF AMERICA, INC.
Install the sensor, engine harness and fuel pipe to the intake manifold. < Refer to ASSEMBLY , Intake Manifold. >
Install the intake manifold. < Refer to INSTALLATION , Intake Manifold. >
Connect the battery ground terminal.

Fig 4: Disconnecting\Connecting Battery Ground Cable
Courtesy of SUBARU OF AMERICA, INC.
Install the collector cover.