LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2011 >> Legacy Premium, Automatic CVT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Engine Mechanical (H6DO)) >> Valve Clearance >> Adjustment >> Exhaust Side

Exhaust Side

WARNING: This page is about a different variant/trim than selected.
  1. Remove the engine from vehicle. Refer to , REMOVAL , Engine Assembly.
  2. Measure all the valve clearances. Refer to , INSPECTION , Valve Clearance.
    NOTE: Record each valve clearance after measurement.
  3. Remove the camshaft. Refer to , REMOVAL , Camshaft.
  4. Remove the valve lifter.
  5. Measure the thickness of valve lifter using micrometer.
    Fig 1: Measuring Thickness Of Valve Lifter Using Micrometer
    G04998619Courtesy of SUBARU OF AMERICA, INC.
  6. Select a valve lifter of suitable thickness using the measured valve clearance and valve lifter thickness, and install it.
    NOTE: Use a new valve lifter.
    Unit: mm (in)
    S = (V + T) - 0.35 (0.0138)
    S: Valve lifter thickness required
    V: Measured valve clearance
    T: Valve lifter thickness to be used
  7. Install the camshaft. Refer to , INSTALLATION , Camshaft.
  8. Install the cam sprocket. Refer to , INSTALLATION , Cam Sprocket.
  9. Install the timing chain assembly. Refer to , INSTALLATION , Timing Chain Assembly.
  10. Measure all valve clearance again at this time. If the valve clearance is not correct, repeat the procedure over again from the first step.

    Valve clearance (adjustment value): 

    0.35±0.05 mm (0.0138±0.0020 in) 

  11. After adjustment, install the related parts in the reverse order of removal.
    NOTE: Use a new rocker cover gasket.
scientia non olet · About LEMON Manuals