Cam Sprocket: Installation

WARNING: This page is about a different variant/trim than selected.

Remove the cam sprocket.
Use the ST to lock the cam sprocket, and install the cam sprocket bolt.
Tightening torque:

Tighten to 29.5 N.m (3.0 kgf-m, 21.8 ft-lb) of torque, and then tighten further by 45°.

ST 499977500 CAM SPROCKET WRENCH
- IN side
  
  Fig 1: Installing Cam Sprocket Bolt Using Special Tool (IN Side)
  Courtesy of SUBARU OF AMERICA, INC.
- EX side
  
  Fig 2: Installing Cam Sprocket Bolt Using Special Tool (EX Side)
  Courtesy of SUBARU OF AMERICA, INC.
Install the timing chain assembly. Refer to , INSTALLATION , Timing Chain Assembly.
Install the chain cover. Refer to , INSTALLATION , Chain Cover.
Install the crank pulley. Refer to , INSTALLATION , Crank Pulley.
Install the V-belts. Refer to , INSTALLATION , V-belt.