LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2011 >> Legacy Premium, Automatic CVT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Engine Mechanical (H6DO)) >> Camshaft >> Removal

Section 15 (Engine Mechanical (H6DO)): Camshaft: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the engine from vehicle. Refer to , REMOVAL , Engine Assembly.
  2. Remove the crank pulley. Refer to , REMOVAL , Crank Pulley.
  3. Remove the chain cover. Refer to , REMOVAL , Chain Cover.
  4. Remove the timing chain assembly. Refer to , REMOVAL , Timing Chain Assembly.
  5. Remove the cam sprocket. Refer to , REMOVAL , Cam Sprocket.
  6. Remove the crank sprocket. Refer to , REMOVAL , Crank Sprocket.
  7. Remove the exhaust oil flow control solenoid valve. Refer to OIL FLOW CONTROL SOLENOID VALVE .
  8. Remove the camshaft position sensor. Refer to CAMSHAFT POSITION SENSOR .
  9. Loosen the rocker cover bolts in the order indicated in the figure, and remove the rocker cover.
    • LH side
      Fig 1: Identifying Camshaft Mounting Bolt (LH Side)
      G07912742Courtesy of SUBARU OF AMERICA, INC.
    • RH side
      Fig 2: Identifying Camshaft Mounting Bolt (RH Side)
      G07912743Courtesy of SUBARU OF AMERICA, INC.
  10. Loosen the camshaft cap bolts equally, a little at a time in numerical sequence, as shown in the figure.
    Fig 3: Identifying Camshaft Cap Bolts Loosening Sequence
    G06649857Courtesy of SUBARU OF AMERICA, INC.
  11. Remove the camshaft caps and camshaft (RH).
    NOTE: Arrange camshaft caps in order so that they can be installed in their original positions.
  12. Similarly, remove the camshaft (LH) and related parts.
scientia non olet · About LEMON Manuals