Engine Mounting: Removal

WARNING: This page is about a different variant/trim than selected.

Change the front hood damper mounting position from (A) to (B), and completely open the front hood.
Tightening torque:

20 N.m (2.0 kgf-m, 14.8 ft-lb)

Fig 1: Identifying Front Hood Damper Mounting Position
Courtesy of SUBARU OF AMERICA, INC.
Remove the collector cover.
Disconnect the ground cable from battery.

Fig 2: Disconnecting Ground Cable From Battery
Courtesy of SUBARU OF AMERICA, INC.
Remove the intercooler. Ref. to REMOVAL , Intercooler.
Remove the radiator main fan motor assembly and radiator sub fan motor assembly. Ref. to REMOVAL , Radiator Main Fan and Fan Motor. Ref. to REMOVAL , Radiator Sub Fan and Fan Motor.
Lift up the vehicle.
Remove the under cover. Ref. to REMOVAL , Front Under Cover.
Remove the front exhaust pipe. Ref. to REMOVAL , Front Exhaust Pipe.
Lower the vehicle.
Support the engine with a lifting device and wire ropes.

Fig 3: Supporting Engine With Lifting Device And Wire Ropes
Courtesy of SUBARU OF AMERICA, INC.
Remove the stopper rod.

Fig 4: Identifying Stopper Rod
Courtesy of SUBARU OF AMERICA, INC.
Remove the bolt and nut which secure engine mounting to the cradle.

Fig 5: Locating Bolt And Engine Mounting Nuts
Courtesy of SUBARU OF AMERICA, INC.
Lift up the vehicle.
CAUTION: When lifting up the vehicle, raise up wire ropes at the same time.
Remove the bolts which secure the engine mounting onto the engine, and remove the engine mounting.

Fig 6: Locating Bolts And Engine Mounting
Courtesy of SUBARU OF AMERICA, INC.