LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2010 >> Legacy Premium, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Cooling System - Cooling (H6DO - 3.6L DOHC)) >> Water Pump >> Installation

Water Pump: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Tighten the bolts in the numerical order as shown in the figure, and install water pump to the oil pan upper.
    NOTE: Use new O-rings.

    Tightening torque: 6.4 N.m (0.7 kgf-m, 4.7 ft-lb) 

    Fig 1: Locating Water Pump Bolts In Tightening Order
    G05667980Courtesy of SUBARU OF AMERICA, INC.
  2. Install the timing chain assembly. Ref. to INSTALLATION , Timing Chain Assembly.
  3. Install the chain cover. Ref. to INSTALLATION , Chain Cover.
  4. Install the crank pulley. Ref. to INSTALLATION , Crank Pulley.
  5. Install the V-belts. Ref. to INSTALLATION , V-belt.
  6. Install the radiator. Ref. to INSTALLATION , Radiator.
  7. Fill engine coolant. Ref. to FILLING OF ENGINE COOLANT , REPLACEMENT, Engine Coolant.
scientia non olet · About LEMON Manuals