LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2009 >> Outback i, Standard >> Repair and Diagnosis >> Transmission >> Manual Trans >> Manual Transmission And Differential 5MT >> Front Differential Assembly >> Removal

Front Differential Assembly: Removal

  1. Remove the manual transmission assembly from the vehicle. Ref. to REMOVAL , Manual Transmission Assembly.
  2. Remove the transfer case together with the extension case assembly. Ref. to REMOVAL , Transfer Case and Extension Case Assembly.
  3. Remove the transmission case. Ref. to REMOVAL , Transmission Case.
  4. Remove the drive pinion shaft assembly. Ref. to REMOVAL , Drive Pinion Shaft Assembly.
  5. Remove the main shaft assembly for single-range. Ref. to REMOVAL , Main Shaft Assembly for Single-Range.
  6. Remove the front differential assembly.
    NOTE:
    • Do not confuse the right and left roller bearing outer races.
    • Be careful not to damage the oil seal of retainer.
      Fig 1: Removing Front Differential Assembly
      G05003046Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the differential side retainers using ST.

    ST 18630AA010 WRENCH COMPL RETAINER

    Fig 2: Identifying ST Wrench Compl Retainer (18630AA010)
    G05003051Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the bearing outer race from the transmission case.

    ST 398527700 PULLER ASSY

scientia non olet · About LEMON Manuals