Transmission Rear CROSSMEMBER And Rear Cushion Rubber
WARNING: This page is about a different variant/trim than selected.
- Install the rear cushion rubber to the transmission.
Tightening torque:
35 N.m (3.6 kgf-m, 26 ft-lb)
- Install the cross.
Tightening torque:
75 N.m (7.6 kgf-m, 55.3 ft-lb)
- Remove the transmission jack.
- Install the heat shield cover.
- Install the center, rear exhaust pipes and the muffler. (Turbo model)
< Ref. to INSTALLATION , Center Exhaust Pipe. > < Ref. to INSTALLATION , Rear Exhaust Pipe. > < Ref. to INSTALLATION , Muffler. >
- Install the front exhaust pipe, rear exhaust pipe and muffler. (Non-turbo model) < Ref. to INSTALLATION , Front Exhaust Pipe. > < Ref. to INSTALLATION , Rear Exhaust Pipe. > < Ref. to INSTALLATION , Muffler. >
- Connect the ground cable to battery.