Water Pump: Installation

WARNING: This page is about a different variant/trim than selected.

Install the water pump onto cylinder block (LH).
NOTE:
- Use a new gasket.
- When installing the water pump, tighten the bolts in two stages in alphabetical sequence as shown in figure.
Tightening torque:

First: 12 N.m (1.2 kgf-m, 8.9 ft-lb)

Second: 12 N.m (1.2 kgf-m, 8.9 ft-lb)

Fig 1: Tightening Sequence Of Water Pump Bolts
Install the hose to water pump.
Install the tensioner bracket.
Tightening torque: 24.5 N.m (2.5 kgf-m, 18.1 ft-lb)

Fig 2: Identifying Tensioner Bracket
Install the belt cover No. 2 (LH).
Tightening torque: 5 N.m (0.5 kgf-m, 3.6 ft-lb)

Fig 3: Locating Belt Cover No. 2 (LH) Bolts
Install the cam sprocket (LH) using ST.
ST 18231AA010 CAM SPROCKET WRENCH

NOTE: CAMSHAFT SPROCKET WRENCH (499207100) can also be used.

Tightening torque: 78 N.m (8.0 kgf-m, 57.9 ft-lb)

Fig 4: Tightening CAM Sprockets Bolts
Install the belt idler No. 2.
Tightening torque: 39 N.m (4.0 kgf-m, 28.9 ft-lb)

Fig 5: Locating Belt Idler No. 2
Install an automatic belt tension adjuster with the tension rod held by a pin. < Ref. to AUTOMATIC BELT TENSION ADJUSTER ASSEMBLY AND BELT IDLER , INSTALLATION, Timing Belt. >
Install the timing belt. < Ref. to TIMING BELT , INSTALLATION, Timing Belt. >
Install the crank pulley. < Ref. to INSTALLATION , Crank Pulley. >
Install the V-belts. < Ref. to INSTALLATION , V-belt. >
Install the radiator. < Ref. to INSTALLATION , Radiator. >