Crank Pulley: Installation

WARNING: This page is about a different variant/trim than selected.

Install the crank pulley.
Install the pulley bolt.
To lock the crankshaft, use ST.

ST 499977100 CRANK PULLEY WRENCH
1. Clean the crankshaft thread using compressed air.
2. Apply engine oil to the crank pulley bolt seat and thread.
3. Tighten the bolts temporarily with tightening torque of 44 N.m (4.5 kgf-m, 33 ft-lb).
4. Tighten the crank pulley bolts.
  Tightening torque:
  
  180 N.m (18.4 kgf-m, 132.8 ft-lb)
  
  Fig 1: Tightening Crank Pulley Bolt Using Crank Pulley Wrench (ST 499977100)
  Courtesy of SUBARU OF AMERICA, INC.
Check that the tightening angle of the clamp pulley bolt is a minimum of 65° Perform the following procedures when less than 65°.
1. Replace the crank pulley bolts and clean them.
  Crank pulley bolt: 12369A A011
2. Clean the crankshaft thread using compressed air.
3. Apply engine oil to the crank pulley bolt seat and thread.
4. Tighten the bolts temporarily with a tightening torque of 44 N.m (4.5 kgf-m, 33 ft-lb).
5. Tighten the crank pulley bolt keeping them in an angle between 65° and 75°.
NOTE: Conduct the tightening procedures by confirming the turning angle of crank pulley bolt referring to the gauge indicated on timing belt cover.
Install the belt tensioner.

Fig 2: Identifying A/C Belt Tensioner
Courtesy of SUBARU OF AMERICA, INC.
Install the V-belts. < Ref. to INSTALLATION , V-belt. >