LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Legacy GT spec.B >> Repair and Diagnosis >> External Pages >> Different car >> Section 64 (Lubrication (H6DO)) >> Oil Pump >> Installation

Oil Pump: Installation

WARNING: This page is about a different car, the 2006 Subaru Outback. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply a coat of engine oil to the whole area of inner rotor and outer rotor.
    Fig 1: Identifying Engine Oil Applying Area On Inner And Outer Rotor
    G05018927
  2. Set the inner rotor onto opening edge of crank shaft, and install the inner rotor, and then assemble the outer rotor.
  3. Install the oil pump cover.
  4. Tighten the bolts in the numerical order as shown in the figure.
    CAUTION: Make sure that the bolt is installed in correct position.

    Tightening torque: 

    6.4 N.m (0.65 kgf-m, 4.7 ft-lb) 

    Fig 2: Identifying Oil Pump Cover Bolts Tightening Sequence
    G05018928
    BOLT INSTALLING POSITION AND DIMENSION

    Bolt installing position Bolt dimension
    (1) and (3) 6 x 14 x 14
    (2) and (4) 6 x 35 x 18
    (5), (6), (7), (8), (9), (10) and (11) 6 x 35 x 15
    (12), (15), (16) and (17) 6 x 16 x 16
    (13) and (14) 6 x 26 x 15
  5. Install the crank sprocket.
  6. Install the timing chain. < Ref. to INSTALLATION , Timing Chain Assembly. >
  7. Install the front chain cover. < Ref. to INSTALLATION , Front Chain Cover. >
  8. Install the V-belts. < Ref. to INSTALLATION , V-belt. >
  9. Install the radiator. < Ref. to INSTALLATION , Radiator. >
  10. Install the under cover.
  11. Fill engine coolant.

    < Ref. to FILLING OF ENGINE COOLANT , REPLACEMENT, Engine Coolant. >

scientia non olet · About LEMON Manuals