LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Legacy GT spec.B >> Repair and Diagnosis >> External Pages >> Different car >> Section 65 (Cooling System (H6DO)) >> Radiator >> Installation

Section 65 (Cooling System (H6DO)): Radiator: Installation

WARNING: This page is about a different car, the 2006 Subaru Outback. However, it is still accessible from the selected car via links, so may be relevant.
  1. Attach the radiator lower cushions to holes on the vehicle.
    Fig 1: Identifying Radiator
    G05018883
  2. Install the radiator to vehicle.
    NOTE: Make pins on the lower side of radiator be fitted into the radiator lower cushions on body side.
  3. Install the radiator upper brackets and tighten the bolts.

    Tightening torque: 

    12 N.m (1.2kgf-m, 8.9 ft-lb) 

  4. Connect the radiator hose.
    Fig 2: Identifying Radiator Hose And Radiator Upper Brackets
    G05018884
  5. Install the reservoir tank. < Ref. to INSTALLATION , Reservoir Tank. >
  6. Connect the connector to the radiator fan control unit.
    Fig 3: Locating Radiator Fan Control Unit Connector
    G05018881
  7. Install the air intake duct.

    < Ref. to INSTALLATION , Air Intake Duct. >

  8. Install the hood stay holder.
    Fig 4: Locating Hood Stay Holder
    G05018880
  9. Lift-up the vehicle.
  10. Connect the ATF cooler hoses.
    Fig 5: Locating ATF Cooler Hose
    G05018879
  11. Connect the radiator hose.
    Fig 6: Locating Radiator Hose
    G05018873
  12. Install the under cover.
  13. Lower the vehicle.
  14. Connect the battery ground cable to battery.
    Fig 7: Connecting Ground Cable To Battery
    G05019586
  15. Fill engine coolant. < Ref. to FILLING OF ENGINE COOLANT , REPLACEMENT, Engine Coolant. >
  16. Check the ATF level.

    < Ref. to INSPECTION , Automatic Transmission Fluid. >

  17. Install the collector cover.
scientia non olet · About LEMON Manuals