Intake Manifold: Disassembly

WARNING: This page is about a different car, the 2006 Subaru Outback. However, it is still accessible from the selected car via links, so may be relevant.

Remove the engine harness from intake manifold.
Remove the throttle body. < Ref. to REMOVAL , Throttle Body. >
Remove the pressure regulator vacuum hose from the intake manifold.

Fig 1: Locating Pressure Regulator Vacuum Hose
Remove the manifold absolute pressure sensor. < Ref. to REMOVAL , Manifold Absolute Pressure Sensor. >
Remove the purge control solenoid valve. < Ref. to REMOVAL , Purge Control Solenoid Valve. >
Loosen the clamp which holds fuel injector pipe to fuel hose, and then disconnect the pipe from fuel hose.

Fig 2: Locating Clamp Screw
Remove the bolts which install fuel pipes on intake manifold.

Fig 3: Locating Fuel Pipes Bolts On Intake Manifold (1 Of 2)

Fig 4: Locating Fuel Pipes Bolts On Intake Manifold (2 Of 2)