LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Legacy GT spec.B >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Engine Mechanical (H6DO)) >> Cylinder Head >> Removal

Cylinder Head: Removal

WARNING: This page is about a different car, the 2006 Subaru Outback. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the crank pulley. < Ref. to REMOVAL , Crank Pulley. >
  2. Remove the front chain cover. < Ref. to REMOVAL , Front Chain Cover. >
  3. Remove the timing chain assembly.

    < Ref. to REMOVAL , Timing Chain Assembly. >

  4. Remove the cam sprocket.

    < Ref. to REMOVAL , Cam Sprocket. >

  5. Remove the crank sprocket.

    < Ref. to REMOVAL , Crank Sprocket. >

  6. Remove the rear chain cover.

    < Ref. to REMOVAL , Rear Chain Cover. >

  7. Remove the camshaft. < Ref. to REMOVAL , Camshaft. >
  8. Remove the cylinder head bolts in the numerical order as shown in the figure.

    Leave bolts (2) and (4) engaged by three or four threads to prevent the cylinder head from falling.

    Fig 1: Identifying Crank Sprocket
    G05018758
  9. While tapping the cylinder head with a plastic hammer, separate it from cylinder block.
  10. Remove the bolts (2) and (4) to remove cylinder head.
    Fig 2: Locating Cylinder Head Bolts
    G05018758
  11. Remove the cylinder head gasket.
    CAUTION: Be careful not to scratch the mating surface of cylinder head and cylinder block.
  12. Similarly, remove the cylinder head (RH).
scientia non olet · About LEMON Manuals