LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Legacy GT spec.B >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Engine Mechanical (H6DO)) >> Camshaft >> Removal

Section 58 (Engine Mechanical (H6DO)): Camshaft: Removal

WARNING: This page is about a different car, the 2006 Subaru Outback. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the crank pulley. < Ref. to REMOVAL , Crank Pulley. >
  2. Remove the front chain cover. < Ref. to REMOVAL , Front Chain Cover. >
  3. Remove the timing chain assembly.

    < Ref. to REMOVAL , Timing Chain Assembly. >

  4. Remove the cam sprocket.

    < Ref. to REMOVAL , Cam Sprocket. >

  5. Remove the crank sprocket.

    < Ref. to REMOVAL , Crank Sprocket. >

  6. Remove the rear chain cover.

    < Ref. to REMOVAL , Rear Chain Cover. >

  7. Disconnect the oil pipe.
    Fig 1: Locating Oil Pipe
    G05018743
  8. Remove the rocker cover (LH).
    Fig 2: Locating Rocker Cover (LH)
    G05018744
  9. Remove the plugs (LH).
    Fig 3: Locating Plugs (LH)
    G05018745
  10. Loosen the camshaft cap bolts equally, a little at a time in alphabetical sequence shown in the figure.
    Fig 4: Identifying Camshaft Cap Bolts
    G05018746
  11. Remove the camshaft caps and camshaft (LH).
    NOTE: Arrange camshaft caps in order so that they can be installed in their original positions.
  12. Similarly, remove the camshafts (RH) and related parts.
scientia non olet · About LEMON Manuals