LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Legacy GT spec.B >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Intake (Induction) (H4DOTC) >> Turbocharger >> Removal

Intake (Induction) (H4DOTC): Turbocharger: Removal

  1. Set the vehicle on a lift.
  2. Remove the collector cover.
  3. Disconnect the ground cable from battery.
    Fig 1: Disconnecting Ground Cable From Battery
    G05019586
  4. Remove the intercooler. < Ref. to REMOVAL , Intercooler. >
  5. Remove the intercooler bracket RH.
  6. Remove the center exhaust pipe. < Ref. to REMOVAL , Center Exhaust Pipe. >
  7. Lower the vehicle.
  8. Separate the turbocharger joint pipe from turbocharger.
    Fig 2: Locating Turbocharger Bolts
    G04998550
  9. Disconnect the engine coolant hose which is connected to coolant filler tank.
  10. Loosen the clamp which secures turbocharger to intake duct.
    Fig 3: Identifying Bolts Securing Turbocharger To Intake Duct
    G04998552
  11. Remove the bolts which secure oil pipe bracket to turbocharger.
  12. Remove the oil pipe from the turbocharger.
    Fig 4: Locating Oil Inlet Pipe
    G04998554
  13. Remove the turbocharger bracket.
    Fig 5: Locating Turbocharger Bracket Bolt
    G05017990
  14. Disconnect the oil outlet hose from pipe.
    Fig 6: Locating Oil Outlet Hose
    G04998556
  15. Take out the turbocharger from engine compartment.
scientia non olet · About LEMON Manuals