LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Baja Turbo, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Manual Transmission And Differential) >> Transmission Mounting System >> Removal >> CROSSMEMBER And Cushion Rubber

CROSSMEMBER And Cushion Rubber

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect ground cable from battery.
  2. Jack-up the vehicle and support it with sturdy racks.
  3. Remove the front and center exhaust pipes. (Non-TURBO model)

    < Ref. to REMOVAL , FRONT EXHAUST PIPE. >

  4. Remove the center exhaust pipe. (TURBO model) < Ref. to REMOVAL , CENTER EXHAUST PIPE. >
  5. Remove the rear exhaust pipe and muffler.
  6. Remove the heat shield cover. (If equipped)
  7. Set the transmission jack under the transmission body.
    CAUTION: Always support the transmission case with a transmission jack.
  8. Remove the rear crossmember.
    Fig 1: Locating Rear Crossmember Bolts
    G04990858Courtesy of SUBARU OF AMERICA, INC.
  9. Remove the rear cushion rubber.
scientia non olet · About LEMON Manuals