Front Exhaust Pipe: Removal

WARNING: This page is about a different variant/trim than selected.

Disconnect battery ground cable.

Fig 1: Disconnecting Battery Ground Cable
Courtesy of SUBARU OF AMERICA, INC.
Disconnect front oxygen (A/F) sensor connector.

Fig 2: Disconnecting Front Oxygen (A/F) Sensor Connector
Courtesy of SUBARU OF AMERICA, INC.
Disconnect rear oxygen sensor connector.

Fig 3: Disconnecting Rear Oxygen Sensor Connector
Courtesy of SUBARU OF AMERICA, INC.
Lift-up the vehicle.
Separate front and center exhaust pipe assembly from rear exhaust pipe.
WARNING: Be careful, exhaust pipe is hot.

Fig 4: Separating Front And Center Exhaust Pipe Assembly
Courtesy of SUBARU OF AMERICA, INC.
Remove under cover.

Fig 5: Identifying Under Cover
Courtesy of SUBARU OF AMERICA, INC.
Remove nuts which hold front exhaust pipe onto cylinder heads.
CAUTION: Be careful not to pull down front and center exhaust pipe assembly.

Fig 6: Locating Front Exhaust Pipe
Courtesy of SUBARU OF AMERICA, INC.
Remove bolt which installs front and center exhaust pipe assembly to hanger bracket.

Fig 7: Locating Center Exhaust Pipe Assembly Bolt
Courtesy of SUBARU OF AMERICA, INC.
Remove front and center exhaust pipe assembly from the vehicle.
CAUTION:
- Be careful not to let front and center exhaust pipe assembly fall off when removing as it is quite heavy.
- After removing front and center exhaust assembly, do not apply excessive pulling force on rear exhaust pipe.
Separate front exhaust pipe from center exhaust pipe.

Fig 8: Identifying Front Exhaust Pipe
Courtesy of SUBARU OF AMERICA, INC.