Remove/Install Paneling On B-Pillar - AR68.30-P-4700SRC
MODEL 453.4
Shown with CODE 810 (Sound system)
| Remove/install | |||
| 1 | Remove paneling from rollover bar | AR68.30-P-1380SRC | |
| 2 | Remove side support | ||
| 3 | Close rear soft top and fold up clamping bracket (1) | ||
| 4 | Remove cover (5) | AR68.30-P-4800SRC | |
| 5 | Remove edge guard (6) up to top edge of B- pillar | ||
| 6 | Remove belt end fitting | *BA91.40-P-1004-01SR | |
| 7 | Unscrew bolt (2) | ||
| 8 | Unclip paneling (4) | ||
| 9 | Disconnect electrical connector from trunk lamp (3) | When removing paneling (4) on left side of vehicle. | |
| 10 | Guide seat belt through paneling (4) and remove paneling (4) | ||
| 11 | Remove bolts (7) | ||
| 12 | Detach catch (8.1) out of body and remove paneling (8) | Carefully detach catch (8.1). Otherwise the catch (8.1) can be damaged. |
|
| 13 | Install in the reverse order |
SEAT BELTS/EMERGENCY TENSIONING RETRACTORS
| Number | Designation | Model 453.4 | |
|---|---|---|---|
| BA91.40-P-1004-01SR | Bolt, belt end fitting to B-pillar | Nm | 21 |