Remove/install thrust arm bushing at the wheel carrier - AR35.20-P-0105EW

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2016 Mercedes-Benz E63 S AMG, 2016 Mercedes-Benz E400, 2016 Mercedes-Benz E350, 2016 Mercedes-Benz E300, and 2016 Mercedes-Benz E250. However, it is still accessible from the selected car via links, so may be relevant.

MODEL 212, 218

Fig 1: Thrust Arm Bushing At Wheel Carrier Remove/Install Components

Courtesy of MERCEDES-BENZ USA

	Remove/install
	Risk of death caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer.	AS00.00-Z-0010-01A
	Notes on self-locking nuts and bolts		AH00.00-N-0001-01A
		While working on the rear axle care must be taken to ensure that the surface of all aluminum components do not get any scratches, cracks and notches. Otherwise the service life of the of the parts will be reduced.
		Tighten nuts and bolts of chassis components only when vehicle is in the ready-to-drive condition.
1	Remove rear wheel		AP40.10-P-4050EW
2	Detach thrust arm (5) from wheel carrier (7)		*BA35.20-P-1002-05G
3	Loosen the thrust arm (5) on the rear axle carrier (1) and fold downwards		*BA35.20-P-1001-05G
4	Remove rubber mount (5l)		AR35.20-P-0105-01CW
4	Remove rubber mount (5l)	Extraction and insertion tool	Figure
5	Install in the reverse order

THRUST ARM

Number	Designation				Model 212	Model 218
BA35.20-P-1001-05G	Self-locking nut, thrust arm to rear axle carrier	M12	Stage 1	Nm	50	50
BA35.20-P-1001-05G	Self-locking nut, thrust arm to rear axle carrier	M12	Stage 2	∠°	90	90
BA35.20-P-1002-05G	Self-locking nut, thrust arm to wheel carrier	M12	Stage 1	Nm	50	50
BA35.20-P-1002-05G	Self-locking nut, thrust arm to wheel carrier	M12	Stage 2	∠°	90	90

Fig 2: Identifying Extraction And Insertion Tool (204 589 03 43 00)

Courtesy of MERCEDES-BENZ USA