Remove/install flywheel/drive plate - AR03.30-P-8001EL
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2016 Mercedes-Benz E63 S AMG, 2016 Mercedes-Benz E400, 2016 Mercedes-Benz E350, 2016 Mercedes-Benz E300, and 2016 Mercedes-Benz E250. However, it is still accessible from the selected car via links, so may be relevant.
ENGINE 157, 276, 278 in MODEL 218
ENGINE 157, 278 in MODEL 212
ENGINE 276 in MODEL 212 (except 212.095/195)
| Remove/install | |||
| 1 | Remove transmission with torque converter | Vehicles without 4MATIC | AR27.10-P-0500EV |
| Vehicles with 4MATIC | AR27.10-P-0500CWX | ||
| 2 | Install retaining lock for crankshaft/starter ring gear | AR03.30-P-5000EL | |
| 3 | Remove screw/bolts (1a) from drive plate (1) | AR03.30-P-8001-02MM | |
Do not use any impact wrench/driver or compressed air tool to screw the bolts (1a) in and out. The thread in the crankshaft flange can get damaged otherwise. |
|||
| *BA03.30-P-1002-01M | |||
| 4 | Remove drive plate (1) from crankshaft flange | ||
| Check | |||
| 5 | Check threaded union (3) in the drive plate (1) | ||
| 6 | Install in the reverse order | ||
| 7 | Carry out first initialization and then sensor rotor adaptation using STAR DIAGNOSIS | When replacing the clutch plate (1). | |
| AD00.00-P-2000-04A | |||
|
FLYWHEEL, DRIVE PLATE, VIBRATION DAMPER, STARTER RING GEAR
| Number | Designation | ENGINE 157 | ENGINE 276 | ||
|---|---|---|---|---|---|
| BA03.30-P-1002-01M | Bolt, starter ring gear/drive plate to crankshaft | Stage 1 | Nm | 20 | 20 |
| Stage 2 | Nm | 45 | 45 | ||
| Stage 3 | ∠° | 90 | 90 | ||
FLYWHEEL, DRIVE PLATE, VIBRATION DAMPER, STARTER RING GEAR
| Number | Designation | ENGINE 278 | ||
|---|---|---|---|---|
| BA03.30-P-1002-01M | Bolt, starter ring gear/drive plate to crankshaft | Stage 1 | Nm | 20 |
| Stage 2 | Nm | 45 | ||
| Stage 3 | ∠° | 90 | ||