Remove/install pop-up bracket on tilting/sliding roof - AR77.20-P-1700CW

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2016 Mercedes-Benz E63 S AMG, 2016 Mercedes-Benz E400, 2016 Mercedes-Benz E350, 2016 Mercedes-Benz E300, and 2016 Mercedes-Benz E250. However, it is still accessible from the selected car via links, so may be relevant.

MODEL 204.0/2 with CODE 414 (Power glass tilting/sliding roof)

MODEL 212 up to model year 2011 with CODE 414 (Power glass tilting/sliding roof)

Shown on right pop-up bracket on model 204.0

Fig 1: Sliding Roof Bracket Remove/Install Components - Shown On Model 204.0

Courtesy of MERCEDES-BENZ USA

	Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Remove
1	Remove water drain rail		AR77.20-P-1997CW
2	Move tilting bracket (1) in "OPEN" direction by actuating sliding roof drive unit until stop (2) can be removed from guide rail (3)
3	Unclip stop (2) from guide rail (3) toward outside of vehicle
4	Remove wind deflector from sliding roof
5	Remove sliding roof drive unit		AR77.20-P-3010CW
6	Move sliders (5) toward front together with tilting bracket (1)	Until guide bolts (7) on lever (4) are located in the recesses (arrows) of the guide rail (3).
7	Fold lever (4) on tilting bracket (1) toward front to vertical position	Carefully fold lever (4). Lever (4) can be damaged.
8	Move sliders (5) toward rear together with tilting bracket (1)	Do not bend lever (4). Lever (4) can be damaged. Until slide shoes (6) are out of guide rail (3). Hold lever (4) in vertical position.
9	Remove tilting bracket (1) from slider (5)
	Install
10	Insert tilting bracket (1) into slider (5)	Do not bend lever (4). Lever (4) can be damaged. Hold lever (4) in vertical position.
11	Push slider (5) toward front with tilting bracket (1)	Until guide pins (7) can be inserted into cutouts (arrows). Ensure that the slide shoes (6) are moved correctly at front into the guide rail (3).
12	Insert guide pins (7) into cutouts (arrows)
13	Push slider (5) toward rear with tilting bracket (1)	Until stop (2) can be installed.
14	Install stop (2)
15	Completely push slider (5) toward front to stop (2). The tilting bracket (1) moves to the tilt position	Ensure that left and right slider (5) are completely seated on stop (2). This ensures that left and right tilting bracket (1) are in same tilt position.
16	Install wind deflector on sliding roof
17	Install sliding roof drive unit		AR77.20-P-3010CW
18	Install water drain rail		AR77.20-P-1997CW